Dodavatel iVIGA Tap Factory
Prepare the installation tools and check whether the supporting parts are complete before installation. Common faucet parts are: hadice, rubber washers, sprchy, odtoky, berle, decorative caps, atd.
Installation of single-hole basin faucet
When buying a single-handle basin faucet, you should pay attention to the diameter of the spout. Dnes, většina vody na trhu patří do tvrdých trubek, so you should pay attention to the height of the upper spout. It is appropriate to go down from the basin 35 work points**. Během instalace, musí být vybrán speciální rohový ventil, a rohový ventil musí být připevněn k potrubí teplé a studené vody ze zdi. Když zjistíte, že mezi rohovým ventilem a vodovodním potrubím na kohoutku je vzdálenost, buy a special extension pipe to connect it. Pamatujte si, you must not use other water pipes to connect, protože pokud je tlak vody vysoký, snadno spadne a propustí vodu, causing you loss. Pokud je vstupní potrubí příliš dlouhé na to, aby přesahovalo výstupní potrubí, díl lze odříznout podle vašich potřeb. Pokud úhel není vhodný, můžete jej ohnout do požadované polohy. Pamatujte si: Do not bend hard to 90 degrees or more than 90 stupně. Při instalaci umyvadla do odtoku, please don’t forget to purchase the small connector of the faucet (short-circuit the faucet). Před instalací nezapomeňte propláchnout vodovodní potrubí zapuštěné ve zdi.
Installation of shower and bathtub faucet (wall hanging)
After you have purchased a shower, vana, or wall-mounted faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Před instalací, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet.
Concealed shower and bathtub faucets: After purchasing a concealed faucet, the valve core of the faucet is generally pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the valve core will not be embedded. Do not remove the plastic protective cover of the valve core easily during pre-embedding, so as to avoid damage to the valve core by cement and other chores. Navíc, you should pay attention to the up and down, left and right directions of the spool when embedding the spool to avoid the wrong spool. When the wall-mounted faucet is pre-embedded in the water inlet pipe, there is a deviation in the size, and the adjustable crutches can be used to adjust the position.
Installation of thermostatic faucet
Před instalací termostatické baterie, please check if the water pipes are hot on the left and cold on the other. Remember not to connect the hot and cold water pipes wrongly to avoid the faucet not working properly. Plynové a solární ohřívače vody nemohou používat termostatické baterie, protože tlak vody je příliš nízký. Při instalaci termostatické baterie nezapomeňte nainstalovat filtr teplé a studené vody.
