iVIGA Tap Factory -toimittaja
The faucet installation is generally installed by workers during decoration, but no one can guarantee that the faucet will not be damaged when it is used in the future. If the faucet is damaged, we can only install it by ourselves. Siksi, it is necessary for the owners to know how to install the faucet. How to install the faucet? The following editor will bring you the installation method of the faucet, and I hope to help you.
How to install the faucet?
Faucet installation method 1, preliminary preparations
Ennen hanan asennusta, check whether the supporting parts are complete and whether the installation tools are complete. Common faucet accessories include hoses, rubber washers, suihkut, decorative caps, crutches, jne.
Faucet installation method 2, clean before installation
Ennen hanan asennusta, clean the water pipe, drain the water to clean the sediment and impurities in the pipe, the impurities in the installation hole, jne., and ensure that the accessories in the box are not mixed with impurities to avoid blocking the valve core during installation.
Faucet installation method 3. Left hot water, right cold water
When taking over the pipe, remember that the hot water pipe is on the left and the cold water pipe on the right. The distance between the two is 100-200mm. After the water inlet pipe joint is fixed, remove the faucet and install the faucet after the wall plasterer is completed. , So as to prevent the surface coating from being polished.
Faucet installation method 4. Single-hole faucet installation
For the single-hole basin faucet, a special angle valve must be selected during installation, and the angle valve must be fixed to the hot and cold water pipes out of the wall. Jos kulmaventtiilin ja hanan vesiputken välillä on etäisyys, you need to purchase a special pipe to extend it. Jos tuloputki on liian pitkä ylittääkseen poistoputken, the part can be cut off as needed. If the angle is not appropriate, it can be bent to the required position appropriately.
Faucet installation method 5. Shower and bathtub faucet installation
If it is a wall-mounted faucet, sinun on valittava sopiva korkeus vesiputken hautaamiseksi, and the distance between the hot and cold water pipes is about 20 cm or more. If it is a concealed faucet, the spool of the faucet should be embedded in the wall. When embedding, pay attention to the thickness of the wall. Do not remove the plastic protective film of the valve core during embedding, so as to avoid cement damage to the valve core during embedding. Lisäksi, pay attention to adjusting the up, alas, vasemmalle, and right directions of the spool during pre-embedding to avoid embedding errors.
