iVIGA Tap Factory Supplier
Prepare the installation tools and check whether the supporting parts are complete before installation. Common faucet parts are: hoses, rubber washers, tuševi, drains, crutches, decorative caps, itd.
Installation of single-hole basin faucet
Prilikom kupovine slavine za umivaonik sa jednom ručkom, you should pay attention to the diameter of the spout. Danas, most of the water in the market belongs to the hard pipe, so you should pay attention to the height of the upper spout. It is appropriate to go down from the basin 35 work points**. Tokom instalacije, mora se odabrati poseban ugaoni ventil, and the angle valve must be fixed to the hot and cold water pipes from the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. Remember, you must not use other water pipes to connect, because if the water pressure is high, it will easily fall off and leak water, causing you loss. Ako je ulazna cijev predugačka da bi premašila izlaznu cijev, the part can be cut off according to your needs. If the angle is not appropriate, you can bend it to the position you need. Remember: Do not bend hard to 90 stepeni ili više od 90 stepeni. Prilikom ugradnje umivaonika za odvod, please don’t forget to purchase the small connector of the faucet (kratko spojite slavinu). Please don’t forget to flush the water pipe buried in the wall before you install it.
Ugradnja slavine za tuš i kadu (wall hanging)
After you have purchased a shower, kada, ili zidnu slavinu, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Before installation, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet.
Ugradne slavine za tuš i kadu: Nakon kupovine skrivene slavine, jezgro ventila slavine je uglavnom prethodno ukopano u zid. Be sure to pay attention to the thickness of the bathroom wall before embedding. Ako je zid pretanak, jezgro ventila neće biti ugrađeno. Nemojte lako skidati plastični zaštitni poklopac jezgre ventila tokom prethodnog ugrađivanja, kako bi se izbjeglo oštećenje jezgre ventila cementom i drugim poslovima. Osim toga, treba obratiti pažnju na gore i dolje, lijevo i desno kalema prilikom ugradnje kalema kako bi se izbjegla pogrešna kalem. When the wall-mounted faucet is pre-embedded in the water inlet pipe, there is a deviation in the size, and the adjustable crutches can be used to adjust the position.
Ugradnja termostatske slavine
Prije ugradnje termostatske slavine, please check if the water pipes are hot on the left and cold on the other. Remember not to connect the hot and cold water pipes wrongly to avoid the faucet not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Don’t forget to install the hot and cold water filter when installing the thermostatic faucet.
