Installation points of different types of faucets

Prepare the installation tools and check whether the supporting parts are complete before installation. Common faucet parts are: hoses, rubber washers, hujan, drains, crutches, decorative caps, dll..

Installation of single-hole basin faucet

Saat membeli keran baskom satu pegangan, you should pay attention to the diameter of the spout. Nowadays, most of the water in the market belongs to the hard pipe, so you should pay attention to the height of the upper spout. It is appropriate to go down from the basin 35 work points**. Selama instalasi, katup sudut khusus harus dipilih, and the angle valve must be fixed to the hot and cold water pipes from the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. Remember, you must not use other water pipes to connect, because if the water pressure is high, it will easily fall off and leak water, causing you loss. Jika pipa saluran masuk terlalu panjang melebihi pipa saluran keluar, the part can be cut off according to your needs. If the angle is not appropriate, you can bend it to the position you need. Remember: Do not bend hard to 90 derajat atau lebih dari 90 derajat. Saat memasang baskom untuk mengalirkan, please don’t forget to purchase the small connector of the faucet (menyebabkan hubungan arus pendek pada keran). Please don’t forget to flush the water pipe buried in the wall before you install it.

Pemasangan kran shower dan bathtub (wall hanging)

After you have purchased a shower, bak mandi, atau keran yang dipasang di dinding, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Before installation, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet.

Keran pancuran dan bak mandi tersembunyi: Setelah membeli keran tersembunyi, inti katup keran umumnya sudah terkubur sebelumnya di dinding. Be sure to pay attention to the thickness of the bathroom wall before embedding. Jika dindingnya terlalu tipis, inti katup tidak akan tertanam. Jangan melepas penutup pelindung plastik inti katup dengan mudah selama pra-penyematan, untuk menghindari kerusakan inti katup oleh semen dan pekerjaan lainnya. Selain itu, Anda harus memperhatikan ke atas dan ke bawah, arah kiri dan kanan spul pada saat menyematkan spul untuk menghindari salah spul. When the wall-mounted faucet is pre-embedded in the water inlet pipe, there is a deviation in the size, and the adjustable crutches can be used to adjust the position.

Pemasangan faucet termostatik

Sebelum memasang faucet termostatik, please check if the water pipes are hot on the left and cold on the other. Remember not to connect the hot and cold water pipes wrongly to avoid the faucet not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Don’t forget to install the hot and cold water filter when installing the thermostatic faucet.